The set holder can be used to replace set hooks or by anybody involved in the distribution or handling of garments.
This innovative product is protected by patent application no. 2001 4587
- Improved handling of large garment volumes
- Elimination of garment damage due to crushing or dropping of garments
- Improved security
- Elimination of hangers falling off rails in transit
- Significant cost saving over set hooks
- Increased vehicle or container utilisation
- Much smaller and easier to recycle
- Two sizes available (standard & half size)
- Can be operated using one hand for increased efficiency
- Combination security seal
Avoid this problem when handling hanging garments
Set holder (standard and half size)
with cable tie over seal bar
Set holder in use - 15 to 30 garments can be transferred swiftly with
one hand
Clothing manufacturers:
- To batch garments for despatch and reduce handling
Clothing retailers:
- To save costs throughout the supply chain
- To maintain garment quality
- To reduce shrinkage by improving security
Transporters & Third-party Logistics companies:
- To improve service quality and reduce costs
- To ensure hangers do not derail in transit
A
batch of garments on hangers (goh) are placed on a rail. The set holder is
then slid over the hanger ends and a cable tie is applied to secure the
seal bar onto the batch of hangers. The set holder is 190mm long, holding
an average 20 garments.
The
set holder is now ready for use and the set of garments can be transferred
onto another rail, trolley or vehicle by lifting the handle. This can be
done using one or two hands.
The cable tie (or seal) is cut at the final destination and the set holder can be slipped off the rail and returned for re-use.
The
set holders are supplied in a box containing 1000 units.